Unit Converter
RPM to Vehicle Speed Converter
Find the road speed for an engine rpm, a gear ratio, a final drive ratio and a tyre size.
RPM to Vehicle Speed Converter examples
| Input | Expected result |
|---|---|
| 3,000 rpm, 1.00 gear, 3.73 final drive, 205/55R16 | 59.5 mph · 95.8 km/h · 804 wheel rpm |
| 2,000 rpm, 0.70 gear, 3.73 final drive, 205/55R16 | 56.7 mph · 91.2 km/h · 766 wheel rpm |
| Overall ratio of 1.00 × 3.73 | 3.73 |
Supported units & limits
Engine rpm must be greater than 0 and at most 1,000,000; gear and final drive ratios are greater than 0 and at most 100. Enter ratios as input turns per output turn, so 3.73 means the driveshaft turns 3.73 times for each wheel turn, and a gear below 1.00 is an overdrive. The tyre uses its nominal unloaded circumference from the size code, so real speed differs with load, wear, pressure and slip, and the speedometer may be calibrated differently. Transfer cases, overdrive and torque converter slip are not modelled. Results use floating-point arithmetic and the selected precision.
Common mistakes
Gear ratio and final drive must both be included: the overall ratio is their product. A lower numeric ratio is a taller gear and gives more speed per engine rpm. Engine rpm is not wheel rpm. Use the tyre actually fitted, because a taller tyre changes the speed at a given rpm. Do not use a rim size or wheel diameter in place of the tyre size.
Privacy
Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.
Conversion guide
Know your ratios and your tyre
Look up the transmission gear ratios and the axle ratio for your vehicle, then enter them with the tyre size. Compare different gears at the same rpm, or different tyre sizes, to see how cruising rpm and top speed change. Use the gear ratio tool to work out the engine rpm for a target speed. Try each gear ratio from the owner's manual in the RPM to Vehicle Speed Converter to build a speed-per-gear table.
RPM to Vehicle Speed Converter FAQ
How do I calculate speed from engine rpm?
Divide the engine rpm by the gear ratio times the final drive ratio to get wheel rpm, then multiply by the tyre circumference. The tool does this and shows mph, km/h and m/s.
What is the final drive ratio?
The reduction in the axle. A 3.73 final drive turns the driveshaft 3.73 times per wheel turn. The gear ratio then applies on top of that, so a first gear of 3.5 gives an overall ratio of 13.1.
Why is my real speed different?
Tyre wear, load and pressure change the rolling circumference, torque converters slip, and speedometers are calibrated with a margin. Compare with GPS for an accurate check.