← Vehicles & Travel

Unit Converter

Gear Ratio to RPM Calculator

Find the engine rpm and wheel rpm at a road speed for a gear ratio, a final drive ratio and a tyre size.

Convert road speed to engine rpm

Result—

Nominal unloaded tyre circumference and no driveline slip. Real rpm differs with load, wear, pressure and slip.

Your calculation stays in your browser.

Gear Ratio to RPM Calculator examples

InputExpected result
100 km/h, 1.00 gear, 3.73 final drive, 205/55R163,132 engine rpm · 840 wheel rpm
70 mph, 0.70 gear, 3.73 final drive, 205/55R162,469 engine rpm · 946 wheel rpm
Overall ratio of 0.70 × 3.732.611

Supported units & limits

Speed must be greater than 0 and at most 1,000,000; gear and final drive ratios are greater than 0 and at most 100, entered as input turns per output turn, so a gear below 1.00 is an overdrive. The tyre uses its nominal unloaded circumference from the size code, so real speed differs with load, wear, pressure and slip, and the speedometer may be calibrated differently. Transfer cases, overdrive and torque converter slip are not modelled. Results use floating-point arithmetic and the selected precision.

Common mistakes

Using only the gear ratio without the final drive gives an engine rpm that is far too low. A numerically higher ratio means higher engine rpm at the same speed. Taller tyres lower the engine rpm at a given speed. If you only know the overall ratio, enter it as the gear ratio and use 1 for the final drive.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.

Conversion guide

Plan gearing before changing parts

Enter the speed you cruise at, the ratios and the tyre size to see the engine rpm. Try a different axle ratio or tyre size to compare, and use the engine rpm tool in the other direction to find the speed at a given rpm. Check manufacturer limits and keep the engine in its usable power band. Changing the final drive ratio in the Gear Ratio to RPM Calculator shows how much a diff swap changes cruising rpm.

Gear Ratio to RPM Calculator FAQ

How do I calculate engine rpm at a given speed?

Convert the speed to wheel rpm using the tyre circumference, then multiply by the gear ratio and the final drive ratio. The tool does all three steps for you.

What rpm will I be at 70 mph?

It depends on the gear, axle ratio and tyres. With a 0.70 overdrive gear, a 3.73 axle and 205/55R16 tyres it is about 2,470 rpm. Enter your own values for your vehicle.

How does tyre size change cruising rpm?

A taller tyre has a longer circumference, so the wheel turns more slowly at the same speed and the engine rpm falls. A smaller tyre does the opposite.