← Chemistry & Concentration

Unit Converter

Gas Concentration ppm to mg/m³ Converter

Convert a gas concentration in ppm by volume to mg/m³, or back, from the molar mass, temperature and pressure.

Convert gas concentration

Result—

Ideal gas at the temperature and pressure you enter. Use the reference conditions of your standard.

Your calculation stays in your browser.

Gas Concentration ppm to mg/m³ Converter examples

InputExpected result
10 ppm CO at 25 °C and 101.325 kPa11.45 mg/m³ · 24.465 L/mol
10 ppm CO at 0 °C and 101.325 kPa12.50 mg/m³ · 22.414 L/mol
11.45 mg/m³ CO at 25 °C10 ppm

Supported units & limits

Assumes an ideal gas and concentrations by volume (mole fraction). The molar mass is an input in g/mol greater than 0. Temperature is in °C from −273.15 up to 4,726.85 and pressure in kPa greater than 0 and at most 10⁶. Values must be greater than 0 and at most 10¹². Real gases at high pressure deviate from ideal behaviour. The tool does not apply humidity or standard-condition rules of a particular regulation, so match the reference conditions of your standard. Results use floating-point arithmetic and rounding follows the chosen precision.

Common mistakes

The result depends on the temperature and pressure, and regulations use different reference conditions such as 0 °C, 20 °C or 25 °C. ppm by volume is not ppm by mass. Use the molar mass of the gas itself, for example 28.01 for CO and 44.01 for CO₂, and not the air average. Do not use this for liquids: the ppm to mg/L tool applies to solutions.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.

Conversion guide

Match the reference conditions

Enter the molar mass of the gas, then the temperature and pressure of your standard or measurement. Convert in the direction you need and note the conditions with the result, since mg/m³ is not meaningful without them.

Gas Concentration ppm to mg/m³ Converter FAQ

How do I convert ppm to mg/m³?

Multiply the ppm by the molar mass in g/mol and divide by the molar volume in litres per mole at your temperature and pressure. At 25 °C and 1 atm the molar volume is 24.465 L/mol.

Why do some sources use 24.45?

They round the molar volume at 25 °C and 1 atm to 24.45 L/mol. The tool computes R × T ÷ P, which gives 24.465, so small differences of about 0.06 percent can appear.

What reference conditions should I use?

Those named by the standard or regulation you are following. Different standards use 0 °C, 20 °C or 25 °C, which changes the result.