← Engineering & Materials

Unit Converter

Flow Velocity to Flow Rate Converter

Convert flow velocity to volumetric flow rate through a pipe or duct, or flow rate back to velocity.

Convert velocity and flow rate

Result—

Steady, incompressible flow with the average velocity over the full area. Use the inside diameter.

Your calculation stays in your browser.

Flow Velocity to Flow Rate Converter examples

InputExpected result
2 m/s in a 100 mm pipe15.71 L/s · 56.55 m³/h · 248.98 gpm
10 L/s through a 100 mm pipe1.273 m/s · 2.85 mph
5 ft/s through 1 ft²5 ft³/s · 2,244 gpm

Supported units & limits

Treats the velocity as the average over the full cross-section and the flow as steady and incompressible, and the area as the open flow area. Diameters, areas, velocities and flow rates must be greater than 0 and at most 1,000,000,000. The tool does not account for partly full pipes, velocity profiles, wall thickness (use the inside diameter), or compressible gas flow at changing density. Results use floating-point arithmetic and rounding follows the chosen precision.

Common mistakes

Use the inside diameter of the pipe, not the outside. A pipe size name such as 4 inch is nominal and its inside diameter differs. The velocity must be the average velocity over the whole area, not the centreline speed. For gases, volume flow changes with pressure and temperature. Mixing units, such as a diameter in millimetres with an area in square metres, gives wrong results, so choose each unit explicitly. Use the inside diameter of the pipe in the Flow Velocity to Flow Rate Converter; the nominal size can be noticeably larger or smaller.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.

Conversion guide

Use the inside area and consistent units

Choose whether to start from a velocity or a flow rate, and describe the flow area by an inside diameter or an area. The tool converts everything through SI units. Remember that velocity is the average across the area, and check the result against a flow meter if you have one.

Flow Velocity to Flow Rate Converter FAQ

How do I convert flow velocity to flow rate?

Multiply the velocity by the cross-sectional area. For a round pipe use π × (d ÷ 2)². A 2 m/s flow in a 100 mm pipe is 15.7 litres per second.

What velocity is typical in a water pipe?

Often about 1 to 3 m/s for water supply lines, but the right value depends on the application, pressure loss and noise limits. Use the tool to see what a velocity means in flow rate.

Does the tool work for gases?

Only at a single density. For gas the volumetric flow changes with pressure and temperature, so state the conditions for the flow rate.