← Engineering & Materials

Unit Converter

Surface Tension Converter

Convert surface tension between SI (N/m, mN/m), CGS (dyn/cm), gram-force and US pound-force units.

Convert surface tension

Result—

Exact definitions are used for each unit. BTU and calorie units are International Table (IT) unless stated.

Your calculation stays in your browser.

Surface Tension Converter examples

The first row uses water near room temperature to show the Surface Tension Converter across units.

InputExpected result
72 mN/m (water)72 dyn/cm · 0.072 N/m · 0.00493 lbf/ft
1 lbf/ft14.594 N/m
1 gf/cm0.980665 N/m

Supported units & limits

Converts a surface tension value, which must be 0 or more, between units. The tool does not look up the surface tension of a liquid, which falls as temperature rises and changes with impurities and surfactants. It does not convert interfacial tension for specific liquid pairs or surface energy of solids. Results use floating-point arithmetic and rounding follows the chosen precision. The tool converts units only; it does not check that a value is physically realistic. Interfacial tension between two liquids uses the same units, so the Surface Tension Converter can convert it as well.

Common mistakes

mN/m and dyn/cm are numerically equal. Do not confuse lbf/ft with the weight of a mass per foot. The surface tension of water is 0.072 N/m, and quoting it as 72 N/m is a thousandfold mistake. Surface tension decreases with temperature, so a table value applies at its stated temperature. Surface energy per area has the same unit but is a separate concept. Surface tension falls as temperature rises, so take the value at the right temperature before using the Surface Tension Converter.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.

Conversion guide

Check the temperature of the value

Surface tension tables state a temperature. Convert to the unit used in your correlation, and use the value at your operating temperature. Wetting and capillary calculations use the same unit.

Surface Tension Converter FAQ

Is mN/m the same as dyn/cm?

Yes. One dyne per centimetre equals 10⁻⁵ N ÷ 10⁻² m = 10⁻³ N/m, which is one millinewton per metre.

What is the surface tension of water?

About 72 mN/m at room temperature, also written 72 dyn/cm or 0.072 N/m. It is lower at higher temperatures.

Can I convert surface tension to surface energy?

The unit J/m² is the same as N/m, so the number is the same for a liquid-vapour interface. They are different ideas, but the units convert identically.