← Engineering & Materials

Unit Converter

Strain Converter

Convert strain (change in length over original length) between ratio, percent, per mille, mm/m and microstrain.

Convert strain

Result—

Exact definitions are used for each unit. BTU and calorie units are International Table (IT) unless stated.

Your calculation stays in your browser.

Strain Converter examples

Below, the Strain Converter works through microstrain, percent and mm/m.

InputExpected result
1,500 microstrain0.15 % · 0.0015 ratio
1 mm/m0.1 % · 1,000 microstrain
2 %20 per mille · 20,000 microstrain

Supported units & limits

Converts a strain value between scales. Negative values are allowed for compression. The tool does not calculate strain from lengths, distinguish engineering from true strain, or convert shear strain angles. Strain gauges report microstrain, and large strains such as percent elongation of plastics are handled by the same scale change. Results use floating-point arithmetic and rounding follows the chosen precision. The tool converts units only; it does not check that a value is physically realistic.

Common mistakes

Strain has no unit, so mm/mm and in/in need no conversion. 1 percent is 10,000 microstrain, not 100. Engineering strain and true (logarithmic) strain are not the same for large deformations, and this tool does not convert between them. Do not treat strain as a percentage of the stress: it is a ratio of length. A strain gauge reading of 500 µε is only 0.05 %, so check the decimal place when the Strain Converter shows percent.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.

Conversion guide

Pick the scale your instrument or standard uses

Strain gauges and structural codes often use microstrain, while material tests report percent elongation. Convert to a ratio when you multiply by a modulus to get stress. Strain gauge software usually reports microstrain, while material tests report elongation in percent; the Strain Converter bridges the two.

Strain Converter FAQ

How do I convert microstrain to percent?

Divide by 10,000. A strain of 1,500 microstrain is 0.15 percent.

Is strain a percentage?

It can be written as one, but strain is simply a ratio of length change to original length. A strain of 0.002 is 0.2 percent, or 2,000 microstrain.

Can strain be negative?

Yes. A negative strain means the length shortens, as in compression. The tool keeps the sign.

What does the Strain Converter show for 1,000 microstrain?

The Strain Converter shows 0.1 %, 1 per mille, 1 mm/m and a ratio of 0.001 for 1,000 µε.