Unit Converter
Roofing Squares Converter
Convert roof area to roofing squares, with pitch, waste allowance and shingle bundles.
Roofing Squares Converter examples
Below, the Roofing Squares Converter works through a footprint, a measured roof and a metric area.
| Input | Expected result |
|---|---|
| 2,000 sq ft footprint, 6/12 pitch, 15 % waste, 3 bundles per square | 22.36 squares · 25.71 to buy · 78 bundles |
| 2,500 sq ft of measured roof surface | 25 squares |
| 100 square metres of roof surface | 10.76 squares (1,076.39 sq ft) |
Supported units & limits
Takes a footprint with a pitch, a measured roof surface area, or a number of squares. Areas must be greater than 0 and at most 1,000,000,000; rise per 12 is 0 to 48; waste is 0 to 100 %; bundles per square are 0 to 100, with 0 skipping the bundle count. The tool assumes one uniform slope, so hips, valleys, dormers and different pitches must be measured and added up separately. Coverage per bundle varies by product. Roughly three bundles per square is common, but heavier shingles need more, so use the product label. Hips, valleys and dormers need extra waste in the Roofing Squares Converter, because the formula assumes one uniform slope.
Common mistakes
A footprint is not the roof area: a sloped roof is larger than the floor below it. Pitch is rise per 12 inches of run, not an angle in degrees. Waste for cutting, valleys and ridge caps depends on how complex the roof is, and the 15 % default is only a starting point. Squares are 100 square feet, not a length. Do not use a measured surface together with a pitch factor, or the slope is counted twice. Shingle bundles per square vary by product; check the wrapper before entering it in the Roofing Squares Converter.
Privacy
Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics, loaded through Google Tag Manager, to count page visits and see which tools are used; Google may set cookies for this. The hosting server may keep standard access logs when you load a page.
Conversion guide
Measure the surface, then order whole bundles
If you can measure the roof directly, enter the surface area. Otherwise enter the footprint and the pitch from a level and tape, or from the plans. Add waste for cuts, then compare the number of bundles with the product’s coverage. Add separate roof sections together before ordering, and ask a roofer to confirm complex roofs. Roofers order a few extra bundles for ridge caps and starter strips beyond what the Roofing Squares Converter counts.
Roofing Squares Converter FAQ
How many squares is my roof?
Measure the roof surface in square feet and divide by 100. If you only have the footprint, multiply it by the slope factor first, such as 1.118 for 6/12, then divide by 100.
How many bundles of shingles are in a square?
Many standard asphalt shingles use three bundles for a square, which is about 33 square feet per bundle. Heavier and specialty shingles can need four or five, so use the coverage on your product’s label.
How much waste should I include?
Common guidance is 10 to 15 percent for simple roofs and up to 20 percent for complex roofs with many valleys, hips and cuts. Pick an allowance that fits your roof and your installer’s advice.