← Engineering & Materials

Unit Converter

Mesh Size to Microns

Look up the nominal aperture in microns and millimeters for a U.S. ASTM E11 sieve number, often called the mesh size.

Look up an ASTM sieve aperture

ASTM E11 designationNo. 200
Nominal aperture
75 µm
Nominal aperture
0.075 mm

Nominal ASTM E11 chart aperture; this is not a generic mesh-count conversion.

Your calculation stays in your browser.

Mesh Size to Microns examples

InputExpected result
ASTM No. 102,000 µm · 2 mm
ASTM No. 20075 µm · 0.075 mm
ASTM No. 32545 µm · 0.045 mm

Supported units & limits

This dated chart snapshot covers ASTM E11 No. 4 through No. 635 alternate designations, corresponding to nominal openings from 4,750 µm down to 20 µm. It does not calculate openings per linear inch from mesh count. Actual sieve openings have manufacturing tolerances and should be checked against the applicable ASTM E11 edition and sieve inspection certificate.

Common mistakes

Do not read “No. 200” as exactly 200 openings per inch or convert mesh count with a reciprocal formula. Wire diameter and the applicable sieve standard matter. Other standards such as Tyler or ISO can use different designations.

Privacy

Conversions run in your browser. This site does not upload or store the values you enter. We use Google Analytics (through Google Tag Manager) to count page visits, and Microsoft Clarity to see how pages are used, such as clicks and scrolling; both may set cookies, and Clarity is set to mask text on the page. The hosting server may keep standard access logs when you load a page.

Conversion guide

Look up nominal ASTM sieve opening in microns

Choose the ASTM E11 alternate No. designation to read its nominal aperture.

Mesh Size to Microns FAQ

Is No. 200 the same as 200 mesh?

This tool treats No. 200 as the ASTM E11 alternate sieve designation for a nominal 75 µm aperture. It is not a generic count of 200 openings per inch.

Why not calculate microns from mesh count?

The opening also depends on wire diameter, and mesh terminology varies by standard and supplier. A generic one-to-one formula would be misleading.

Are these measured openings exact?

They are nominal chart apertures. ASTM E11 allows manufacturing tolerances; use a certified sieve specification for inspection work.

Does this cover Tyler mesh?

No. It looks up the ASTM E11 column only. Verify designations from Tyler or ISO tables separately.